Skip to content

Areas we cover

Radiant Heat In Aurora

Altitude-adjusted radiant heat for Aurora homes.

What We Do

Services We Provide in Aurora

From heated driveways to whole-home radiant floors, we arrange assessments and written scopes for every radiant heat project.

View all services

Aurora Heat Done Right

Zone-controlled warmth sized for Aurora’s housing stock

From ranch homes near Crescent Park to newer builds off Fitzsimons, every system starts with a load calculation, not a guess.

Aurora spans a wide range of housing eras and layouts. Older ranch-style homes common near East Colfax and North Aurora often have minimal under-floor insulation, which affects how a hydronic manifold is sized and where heat loss is greatest. An altitude-adjusted BTU evaluation accounts for those variables before any pipe or cable is specified.

Newer construction near the Lowry and Central Park corridors tends to have tighter building envelopes, which can make electric radiant a practical fit for bathrooms or spot zones without a full boiler loop. The assessment determines which system type matches the space, then a written, itemised estimate covers equipment, scope, and timeline before scheduling begins.

Outdoor snow melt is also common in Aurora driveways and walkways. Those lines are scoped with glycol mix requirements and freeze protection built in from the start, not added as an afterthought. A post-install performance check confirms the system reaches its specified BTU output before the project is considered complete.

A radiant heat job seen in full

Local questions

Questions we get in Aurora

What is the downside of radiant heat?

Radiant systems heat slowly compared to forced air, so they work best when left at a steady setpoint rather than cycled on and off. Hydronic systems also require a boiler, manifold, and pressure-tested tubing, which means higher upfront installation costs than a furnace swap. The tradeoff is even, draft-free warmth and lower long-term operating costs.

Does radiant heat use a lot of electricity?

Hydronic radiant runs on a boiler, so electricity use is limited to the pump and controls, typically modest. Electric radiant mats draw more power directly, making them better suited to smaller zones like bathrooms than whole-home heating. The load calculation identifies which system type keeps operating costs in check for your specific space.

What temperature should radiant floor heat be set at?

Most hydronic floor systems run the slab or subfloor surface between 75 and 85 degrees Fahrenheit, which keeps the room air comfortable without overheating the floor. The exact water supply temperature depends on the floor finish, insulation below the slab, and the altitude-adjusted BTU output required for the space.

Should I turn off my radiant heat in the summer?

You can lower the setpoint significantly, but shutting a hydronic system off entirely and restarting it in autumn puts unnecessary stress on the boiler and pump seals. Keeping it at a minimal standby temperature maintains glycol circulation and protects components. Your installer will set a recommended summer setpoint during the post-install walkthrough.

Arrange Your Radiant Heat Assessment

Every enquiry includes a system evaluation and a written estimate before any work is booked.

Request an Assessment